Acceptance of suspended permanent magnet iron remover should be carefully regulated- RCYD
the email of beltmagnets factory

HomeNews › Acceptance of suspended permanent magnet iron remover should be carefully regulated

Acceptance of suspended permanent magnet iron remover should be carefully regulated

After the suspended permanent magnet iron remover is bought, the first thing to be done is to check and accept. When the equipment is accepted, the test machine operation must be performed. In the process of acceptance, it is important to be careful and conscientious.

1. First check whether the connection at both ends of the hanging device is reliable.

2. Check whether the track limit device of the walking trolley is safe and reliable and whether the trolley running is stable.

3. After walking the trolley to reach the suction and discarding iron limit, the center of the iron remover should be aligned with the belt center and the abandoned iron trolley center.

4. If two electromagnetic iron removers are installed on a belt, check whether the alternate operation of the two machines is correct and in place according to the program control requirements. Is it stable and reliable, and each of the blank loads must be no less than 10 times. Test, without any problems, can be judged as qualifying.

5. After putting into production trial operation, pay special attention to observe the operating status of the host. Suction and iron rejection ability, stop position after the limit is not accurate. Programs that run alternately are not confused.

6, to observe the operation of the iron remover and the ability to suck and reject iron. We is able manually input the iron and iron of different weights and shapes into the material to be conveyed, detect the suction and abandonment ability of the main machine, and adjust the lifting height or inclination when necessary.

 

Suspended permanent magnet