After buying back the suspension magnetic separator, check the goods before using- RCYD
the email of beltmagnets factory

HomeBlog › After buying back the suspension magnetic separator, check the goods before using

After buying back the suspension magnetic separator, check the goods before using

After the suspension magnetic separator purchased by many users arrives, they can’t wait to put it into production, and ignore the problem of equipment acceptance? What I want to tell you here is that after the equipment arrives, do n’t rush to use it, it is very important to do the acceptance work, so what are the acceptance specifications for the suspension magnetic separator?

1. First check both ends of the suspension device of the suspension magnetic separator to see how reliable the connection is;
2. Confirm whether the track limit device of the walking car is safe and reliable, and whether the traveling process of the car is stable;
3. Whether the walking trolley moves back and forth to the iron suction, after the iron discard limit, whether the center of the suspension magnetic separator is aligned with the center of the belt and the iron discard trolley
4. If two suspension magnetic separators are installed on the same conveyor belt, it is necessary to check the alternating operation status of the two machines according to the program control requirements to see whether they are accurate and stable. Each equipment must be tested at least ten round trips without load, without any problems, before it can be put into trial production operation;
5. After the suspension magnetic separator is put into production trial operation, pay special attention to observe and check the operation status of the host, and the accuracy of the stop position after the iron absorption and iron discard reaches the limit. Is the alternating operation procedure confusing.
6. Confirm the operation status of the suspension magnetic separator and its ability to absorb and discard iron. You can manually put mixed iron with different weights and shapes into the materials to be processed to test the host’s ability to absorb and discard. Or the inclination angle should be adjusted appropriately.

Suspended permanent magnet