Bearing maintenance of suspended permanent magnet iron remover must be done- RCYD
the email of beltmagnets factory

HomeBlog › Bearing maintenance of suspended permanent magnet iron remover must be done

Bearing maintenance of suspended permanent magnet iron remover must be done

Correct use and maintenance of the suspended permanent magnet separator is a prerequisite for its good operation. When the suspended permanent magnet separator is turned on, the water should be fed again. When the machine is shut down, the mine should be stopped and then stopped. reverse. In the suspended permanent magnet iron remover, the bearing is a very important component, so do not care about the maintenance of the bearing, then what should be done in the maintenance of the suspended permanent magnet separator? Let’s take a look at some of the details of the maintenance of the suspended permanent magnet separator.
Generally speaking, the suspended permanent magnet iron remover needs to clean the bearing after running for more than three hundred hours, and then the lubricating oil is added. The filling amount of the lubricating oil is preferably one third of the bearing seat space, and at most, it is not necessary. More than one-half, only need to properly tighten the cap-type oil cup cover before hanging the permanent magnet separator. However, when the bearing of thesuspended permanent magnet separator is worn or damaged, it should be replaced immediately, and the lubrication of the bearing should be paid attention to.

suspended permanent magnet