Description of the start and stop control of suspended permanent magnet iron remover
The control of suspended permanent magnet separator mainly includes two main aspects, namely, starting and stopping. How do these two control modes of permanent magnet separator work? You can refer to the following content, I believe that everyone can be more comfortable to operate.
1. Start of suspended permanent magnet iron remover: The start of suspended permanent magnet iron remover is run with the start of the belt conveyor. After the belt conveyor is started, a set of normally open contacts on the joint relay in the high voltage control cabinet will be connected. Tong, suspended permanent magnet iron remover began to run after receiving the operation instructions.
2. Stopping of suspended permanent magnet iron remover: The belt machine of suspended permanent magnet iron remover stops, the joint relay on the belt machine control cabinet will lose power, and the contact in the normally open state will be separated again; if it is for suspended permanent magnet separator is set to stop the delay. After the relay is powered off for 10 minutes, the suspended permanent magnet separator will end.
The two main control modes of suspended permanent magnet iron remover are the above. Don’t forget the correct operation and timely maintenance when you use it normally.
- How should the Overband Magnet iron remover meet safety technical requirements during installationApril 09, 2020
- What are the outstanding aspects of the design of the light suspension magnetic separatorApril 08, 2020
- Development of industrial technology points new direction for suspension magnetic separatorApril 03, 2020
- This is the right operation for the purchase of suspension magnetic separatorApril 02, 2020
- How to avoid making mistakes in the selection of suspension magnetic separatorMarch 31, 2020
Contact: Bright Han
Factory Add：No. 2798 Yongjun Road, Weicheng District, Weifang City, Shandong Province, China