Do not ignore the maintenance of suspended permanent magnet separator bearings
The bearing is not important for the suspended permanent magnet separator. Generally, after the permanent magnet separator is in operation for 300 hours, the bearing needs to be maintained. First, it must be cleaned and then lubricated. For oil, the added lubricating oil should be one-third of the bearing seat vacancy, and generally should not exceed one-half at most. Only the cap-type oil cup cap needs to be tightened before the suspended permanent magnet separator works. A small amount is fine.
If the bearing is worn out when the maintenance of the suspended permanent magnet separator is serious or even damaged, it must be replaced immediately, and attention should be paid to the lubrication of the bearing. The screen of the suspended permanent magnet separator is made of thin steel plate or iron sheet punching. After a long time of use, the screen may be worn or broken by other objects. If the damaged area is not too large, It can be repaired, and if the damaged area is too large, it can only be replaced.
- This is the right operation for the purchase of suspension magnetic separatorApril 02, 2020
- How to avoid making mistakes in the selection of suspension magnetic separatorMarch 31, 2020
- Which aspects of suspension permanent magnets are better than similar equipmentMarch 26, 2020
- Why can the suspension magnetic separator usher in development opportunitiesMarch 25, 2020
- Is there a better way to improve the effect of the suspension magnetic separator than multiple iron removals?March 21, 2020
Contact: Bright Han
Factory Add：No. 2798 Yongjun Road, Weicheng District, Weifang City, Shandong Province, China