Five points about the use of Overband Magnet separator- RCYD
the email of beltmagnets factory

HomeBlog › Five points about the use of Overband Magnet separator

Five points about the use of Overband Magnet separator

Among the many iron separator equipments, the Overband Magnet iron remover is a kind of common application nowadays. When the material containing magnetic iron element flows through the pipeline, the iron impurities will be adsorbed on the pipe wall, and the automatic removal is very simple. Save time and effort, then what are the main points about the use of Overband Magnet separators?
1. The preparation work before the start of the Overband Magnet iron remover should be done well. Check if the mouth cover of the pipeline is open. If there are too large parts inside, do not discharge it. If it is, clean it immediately. Boot up.
2. Regarding the machine failure problem, if the Overband Magnet separator is faulty in use and it is not convenient for maintenance and repair, the power should be disconnected first, and the technician should repair it.
3. The dust cleaning on the Overband Magnet iron remover should refer to the actual situation. In principle, it should be cleaned once a week. However, if the dust in the workshop is relatively large, it can be cleaned once every two days, mainly to ensure the cleaning of the equipment. Clean, does not hinder work, cleaning time is based on actual conditions.
4. The problem of adding time control of lubricating oil. It is advisable to add lubricating oil for Overband Magnet iron remover once every six months. Add lubricating oil between each bearing gear and replace the lubricating oil inside the fuel tank once a year.
5. Finally, if there is a lot of powder in the iron mouth during use, this is not a concern. It is a normal phenomenon. This is because the ferromagnetic content of the treated powder is high.

 

Overband Magnet