Home› Blog › For the maintenance of Overband Magnet separator, you need to follow these steps
For the maintenance of Overband Magnet separator, you need to follow these steps
Overband Magnet iron remover has become an indispensable iron remover in many industries in China. As a very important iron remover, belt iron remover should be properly maintained during use to ensure its good operation. Status, so do you know what specific steps to follow in the maintenance of the Overband Magnet separator? Here is a summary for everyone.
1. After the Overband Magnet separator is installed, it must be run in the air first, and the running time must not be less than two hours.
2. When the Overband Magnet separator is running, the motor reducer and the strong screws of the bearing housing of the seal cover must be secure, and the contact surface with the frame must be tight, and the phenomenon of seeing feet cannot occur.
3. The rolling bearings at both ends of the cylinder should have sufficient grease, the reducer must have an appropriate amount of lubricating oil, and the screw rod of the magnetic system adjustment device should be coated with lubricating oil.
4. The cylinder should be moved by hand. It should be flexible to rotate and there should be no abnormal sound.
5. The two gears must run in at no load. The running time must be no less than 1 hour.
6. The tooth side clearance of the meshing gear is 0.085mm. The contact area must not be less than 40% along the tooth height and not less than 70% along the tooth length.
7. After the Overband Magnet separator is running, clean it, fasten the cover of the sealed box, and tighten the screws.
8. Fill in the lubricating oil and continue the test run for 1 hour. The sealed box must not show oil leakage or oil leakage. It is normal for the internal friction of the magnetic drum to not affect the normal use.
9. If any abnormal phenomenon is found in the cylinder and transmission parts during the trial operation of the Overband Magnet iron remover, it shall be inspected and repaired in time.
News
- Iron removal equipment manufacturers take you to have a deep understanding of the suspension magnetic separatorMay 07, 2020
- How to repair the belt of the Overband Magnet iron removerApril 29, 2020
- What aspects of the suspension magnetic separator have been improved to meet the market demandApril 27, 2020
- What are the applications of different types of suspension permanent magnetsApril 25, 2020
- What is the significance of suspension permanent magnet for raw material productionApril 23, 2020
Contact Us
Contact: Bright Han
Phone: 18863665265
Tel: 0536-8919027
E-mail: Magnetoelec@beltmagnets.com
Factory Add:No. 2798 Yongjun Road, Weicheng District, Weifang City, Shandong Province, China