How to repair the belt of the Overband Magnet iron remover
In the process of using the Overband Magnet iron remover, it is often necessary to face the problem of damage to the belt. For example, when the belt breaks, it must be repaired as soon as possible to reduce the loss caused by the shutdown. Everyone can repair it for less damage or in an emergency. . Here is how to quickly repair the method of Overband Magnet iron remover.
First, use an electric peeling machine to cut a repair area of 3 mm deep in each 40 mm area on both sides of the crack, and cut out 5 cm at the same time, and perform the repair operations of steps 2 to 4.
In the second step, apply the primer to the area to be repaired, mix the special repair glue and pour it into the repaired area to make it smooth.
Here, we need to remind everyone that we must pay attention to two points: the amount of repair glue in each group is 3.5 meters (400 grams); 15 minutes after applying the primer, add the glue again.
The third step is to add special repair rubber while smoothing the repair of the glue, and repeat the rolling twice with special rollers.
The fourth step, in order to reduce the standby time, the upper heating blanket heats the repaired surface (when the temperature exceeds 15 degrees, this step can be omitted).
The fifth step is to apply a certain pressure on the repaired surface to make the bonding surface flat.
- Iron removal equipment manufacturers take you to have a deep understanding of the suspension magnetic separatorMay 07, 2020
- How to repair the belt of the Overband Magnet iron removerApril 29, 2020
- What aspects of the suspension magnetic separator have been improved to meet the market demandApril 27, 2020
- What are the applications of different types of suspension permanent magnetsApril 25, 2020
- What is the significance of suspension permanent magnet for raw material productionApril 23, 2020
Contact: Bright Han
Factory Add：No. 2798 Yongjun Road, Weicheng District, Weifang City, Shandong Province, China