How to replace the self-cleaning belt of the self-cleaning permanent magnet separator- RCYD
the email of beltmagnets factory

HomeBlog › How to replace the self-cleaning belt of the self-cleaning permanent magnet separator

How to replace the self-cleaning belt of the self-cleaning permanent magnet separator

How to replace the self-cleaning belt of the self-cleaning permanent magnet separator

1. Loosen the bolt of sprocket cover and remove the cover and sprocket
2. Loosen the bearing adjusting device of the driven pulley, loosen the bolts of the bearing seat of the main and driven pulleys, remove the pulley from the bench, and remove the supporting rollers above the bench.
No magnetic roller2
3. Loosen the bolt of the iron remover body, lift the bench, and take out the old belt at the same time.
4. Start to install new belt (non-magnetic scraper should be installed first, bolt tightening and welding stop). Please note that the direction of a scraper is the same as that of unloading belt.
5.Spread the stripping belt on the ground, take one side of the stripping belt upward, hang the stripper body into the stripping belt, and pad the stripper body diagonally so as not to crush the belt, and then insert the main and driven pulleys into the belt.
6.Hang the bench above the magnetic separator body and fasten the body and the bench.
7.When the main and driven pulleys and idlers are positioned correctly, they are fixed on the bench.
8.Install the chain, adjust the tightness of the chain and cover it well.
9. Adjust the bearing adjusting device to ensure proper belt-tightening.
10. Check all installation bolts, confirm that they have been tightened, and start the reducer.
overbelt magnet