Learn how to test the suspension magnetic separator before putting it into use- RCYD
the email of beltmagnets factory

HomeBlog › Learn how to test the suspension magnetic separator before putting it into use

Learn how to test the suspension magnetic separator before putting it into use

Suspension magnetic separator is an auxiliary equipment inseparable from many enterprises. When using iron separators, in order to avoid various problems after the official opening, which affects the production progress, it is necessary to do a good job in test machine So, do you know how the test machine of the suspension magnetic separator was carried out? Here are five key points for everyone:

1. Suspension magnetic separator is filled with 25 # transformer oil before commissioning, if the transformer oil is not filled before leaving the factory, the oil volume is controlled at 1/3 of the oil standard.
2. Before the suspension magnetic separator is put into production, a 1000 volt megohmmeter is used to test the insulation resistance of the winding to the magnet case, and its value should be above 10MΩ.
3. The suspension type magnetic separator must check the excitation winding and the reducer motor wiring before starting to confirm whether it is correct and firm, and whether the lubrication points on the reducer have been sufficiently lubricated. If the self-unloading belt turns incorrectly after starting operation To be corrected.
4. Check the tightness of the unloading belt and chain. Too loose or too tight will affect the normal work of the unloading mechanism. If the self-unloading belt is improperly tightened or misaligned, the screw on the bearing seat at both ends of the driven roller can be adjusted to resume normal operation.
5. After a comprehensive inspection confirms that there are no problems, it can be officially started and put into production.

 

Suspended permanent magnet