Pay attention to the standard operation when adjusting the belt of the suspension magnetic separator

The suspension magnetic separator is composed of the main body of the iron remover and the iron unloading mechanism. One of the core components of the iron unloading device is the unloading iron belt. During the operation of the suspended magnetic separator, the problem of belt deviation is extremely easy to occur. So, how to adjust the belt of the suspension magnetic separator?
When the suspension magnetic separator is installed, it should be installed horizontally as much as possible. If the belt is deflected, the support of the roller should be adjusted first. If all the roller bearings have been adjusted and the belt is still biased, then the belt needs to be adjusted. Adjust the bearing housing of the driven roller. That is, according to the direction of the belt prompting direction, the belt is biased toward which side, and the roller support is adjusted according to the direction of the belt. If the belt is still deflected, adjust the driven roller bearing housing in the direction shown.
When adjusting the belt of the suspension magnetic separator, be careful not to step on the belt during the belt adjustment process, otherwise the belt adjustment effect will be affected. If the belt runs a lot to one side, any two phases of the three-phase motor input line can be exchanged, and the belt will move to the other side in the opposite direction, and will stop when moving to the middle of the suspension magnetic separator, and then change again. Any two phases of the motor, let the belt run in the normal direction, and then adjust according to the specific adjustment method of the belt running deviation. After the belt is no longer deflected, the belt should be stably operated for 2 hours in the middle of the suspension magnetic separator. During the operation period, the running condition should be observed. If there is deviation, it should be adjusted in time.