Points for attention in the transportation and mounting of suspension permanent magnets- RCYD
the email of beltmagnets factory

HomeNews › Points for attention in the transportation and mounting of suspension permanent magnets

Points for attention in the transportation and mounting of suspension permanent magnets

During the installation of any mechanical equipment, the corresponding installation requirements must be observed to avoid unexpected situations and avoid accidents. The same applies to the use of iron removers. Suspension permanent magnet are widely used in industry and are favored by many users because of their unique product characteristics. Suspension permanent magnets have many installation requirements during the installation process, such as requiring a large installation space to facilitate the transportation and lifting of the iron remover. During the installation process, you also need to keep in mind the installation precautions to ensure the normal use of the floating permanent magnet. Next, we will introduce the requirements for the suspension and installation of suspension permanent magnets.

When moving the suspension permanent magnet, it is necessary to use lifting equipment. When lifting, the steel cable should be put on the lifting ring of the suspension permanent magnet. Before lifting, check whether the hanger, lifting rigging and the iron separator are installed. Loosen and ensure that it can be lifted behind.

The hanging device is to connect the iron remover to the moving trolley, and the height of the lifting is 450 mm vertical distance from the bottom of the iron remover to the outer surface of the conveyor belt. When installed in the middle, the suspension permanent magnet body should be kept horizontal. When the head is installed, the suspension permanent magnet should be inclined at an angle of 15° to 30° with the conveyor head wheel. The center of the iron remover should be offset from the center line of the conveyor head wheel by 150 to 200 mm, and the interval is from the bottom of the iron remover to the belt head. The wheel exterior is mounted at a height of 450 mm.

suspended permanent magnet