Principles for the operation of Overband Magnet separator operation- RCYD
the email of beltmagnets factory

HomeBlog › Principles for the operation of Overband Magnet separator operation

Principles for the operation of Overband Magnet separator operation

For the use of Overband Magnet separators, rules and regulations should be observed at all times, and they should not be arbitrary. This principle is not only applicable to the production of iron separators, but also applies to the normal operation of the whole society. Rules can guarantee normal order, and strategies can improve the efficiency of work. This is the case in the use of Overband Magnet separators. Here, the technical experts of Henderson Magnets explain the principles of the use of Overband Magnet separators.
Before the Overband Magnet iron remover is turned on, the operator should open the observation port cover and check whether there are any large iron pieces on the inner separator of the pipe automatic separator (especially the tap hole). If it is, be sure to clean it before starting the machine. Every shift of staff must clean the dust on the geared motor; every six months, the gearing hole of the geared motor and the chain of the machine side should be added with calcium grease once; every 24 months, the oil in the oil groove at the bottom of the chassis will be used. Replace once, if the temperature of the material exceeds 100 degrees Celsius, shorten the oil change time.

Overband Magnet