Selection points of diameter of iron rods for Overband Magnet iron remover- RCYD
the email of beltmagnets factory

HomeNews › Selection points of diameter of iron rods for Overband Magnet iron remover

Selection points of diameter of iron rods for Overband Magnet iron remover

When using the Overband Magnet iron remover to remove the diameter of the iron rod, it should not be too large, because increasing the surface area of ​​The magnetic source and the iron impurities contact can improve the chance of capturing the prey, although increasing the straight through can increase the surface area of ​​A rod. However, under the premise of the same weight of the iron source material, reducing the straightness of the magnetic rod can increase in the number of roots, which can greatly increase the surface area. When the cross section of the large flow slurry is high, it can be processed in the form of a multi-layer magnetic rod stack; the old magnetic rod is magnetized and refurbished, as long as the sleeve of the magnetic rod is not rotten, the magnetic core is not oxidized and deteriorated, and the refurbishment can reach the original The level of use, the same effect, investment can save about 50%.

In the same production line, permanent magnet electromagnetic mixing can be used. First, the iron separator with low price and a weak magnetic field is used to remove the strong magnetic iron impurities. The purchase price and the usual cost are relatively high, but the magnetic field is strong. High-power Overband Magnet separator. When working, there should be no instrumentation around to avoid interference with the instrument. There should be no dust around the Overband Magnet iron remover. If it is, it should be cleared up in time. Before using it, check it first to see if there is an issue and if it is not available.

Overband Magnet