Start-stop control process of suspended permanent magnet separator- RCYD
the email of beltmagnets factory

HomeBlog › Start-stop control process of suspended permanent magnet separator

Start-stop control process of suspended permanent magnet separator

As we all know, the suspended permanent magnet iron remover can effectively remove the ferromagnetic impurities mixed in the material, which is an indispensable iron remover equipment in modern industrial production. In the operation control of the suspended permanent magnet separator, the main The two control points are the start and stop of the equipment. What is the process of starting and stopping control of the suspended permanent magnet separator? Below, the technicians of Henderson Magnetron will briefly introduce the working conditions of the two control modes of the suspended permanent magnet separator:
1. The start of the suspended permanent magnet separator is synchronized with the start-up operation of the belt conveyor. When the belt conveyor starts to operate, the contact switch on the joint relay in the high-voltage control cabinet of the equipment is turned on, and the suspended permanent magnet is removed. The iron will start running after receiving the running command.
2. The belt conveyor of the suspended permanent magnet separator is finished, the closing relay inside the belt conveyor control cabinet is disconnected, and the contact switch is also separated; the suspended permanent magnet separator is provided with a function of delaying shutdown. Ten minutes after the relay is de-energized, the suspended permanent magnet separator will end.

suspended permanent magnet