Summarization of common fault resolution measures for suspension magnetic separator- RCYD
the email of beltmagnets factory

HomeBlog › Summarization of common fault resolution measures for suspension magnetic separator

Summarization of common fault resolution measures for suspension magnetic separator

Suspension magnetic separator should not be uncommon in industrial production. Although this model is convenient to use and can save a lot of labor, it will inevitably encounter various problems during use. Some minor problems may be solved by everyone, but there are some more difficult problems, which are very troublesome to solve. Whether it is for the operator or the technician, if you can understand some of the faults that will occur in the suspended magnetic separator in advance, you can quickly check and solve them when the fault occurs. Let’s briefly introduce you to these failures.

One of the most common failures in the use of suspension magnetic separator is insufficient suction. After using it for a period of time, the attractiveness drops, and no more heavy objects can be lifted. At this time, if experienced operators or technicians can immediately think of some hidden problems inside it, such as resistance short circuit, it may also be The coil is not in good contact, and it may even be burnt out directly.

After understanding the general cause of the failure of the suspension magnetic separator, the resistor and the coil should be dealt with accordingly, so as to restore it to its original attraction, and the work can be carried out normally. Another possible fault is that there is residual magnetism. We know that when the power is turned off, there will be no residual magnetism originally, that is, there will be no attraction, and now there is residual attraction, what is the cause of this failure? It may be caused by the demagnetization voltage being too high. Finally, the demagnetization resistor is damaged. The other is that the line in the demagnetization resistor is damaged, or the resistance itself is broken. The most common solution to this kind of fault is to adjust the demagnetization voltage or replace the demagnetization resistor.

suspended permanent magnet