Summary of the operational requirements for the installation of the Overband Magnet- RCYD
the email of beltmagnets factory

HomeNews › Summary of the operational requirements for the installation of the Overband Magnet

Summary of the operational requirements for the installation of the Overband Magnet

If the Overband Magnet is to be installed properly and can be operated normally, it is a necessary precondition for installation in a suitable place. Correct installation and reasonable operation are the key to ensure the iron removal efficiency and operation effect of the iron remover. Today, Henderson Magnetism gives you some important items for the installation and operation of some pipe separators. I hope everyone can pay more attention.
After the power is connected, the first time you turn on the power, you must observe whether the direction of the equipment is running correctly. If the direction of the motion is not correct, you should immediately shut down and change the direction of the motor before attempting.
Before the operation of the Overband Magnet, it is necessary to adjust the start and stop time of the motor according to the amount of ferromagnetic impurities contained in the powder. Adjust the time relay button inside the electric control box to change the two times. The value can be changed. Observe directly through the button. Pads or asbestos ropes must be placed between the inlet and outlet flange joints to ensure the sealing performance of the joints to prevent dust from eroding the environment.
Overband Magnet must not allow too large iron blocks to enter the machine during operation, so as to avoid the failure of the magnet group or affect the effect of iron removal, the operator should pay attention to it.

Overband Magnet