Suspended permanent magnet iron remover felt ring must be replaced in time

The felt strip of the side sprocket cover of the suspended permanent magnet separator and the lower felt sprocket of the large sprocket are designed to ensure the sealing and effective breathing of the chassis, and can not be damaged during the inspection; the felt ring wears after long-term use. Replace it in time. If the powder has a small particle size (≤ 1mm), the ferromagnetic content is higher. The powder that is entrained in the discharge of the taphole will increase, which is a normal phenomenon. Before starting the machine, the operator should open the observation port cover and check whether there are any large iron pieces that cannot be discharged on the separator inside the iron remover (especially the tap hole). If it is, it must be cleared before it can be turned on.

The dust on the suspension type permanent magnet iron reducer motor should be removed every shift; the oil injection hole of the geared motor and the chain on the machine side should be added with calcium grease once every six months; once every twelve months, the oil in the oil tank at the bottom of the chassis should be once. Replacement, if the temperature of the material exceeds 100 ° C, the oil change time should be shortened. In the event of a mechanical failure of the suspended permanent magnet separator, and the production line is temporarily inconvenient to stop, the power supply can be disconnected, and the operator can take out the iron by the observation port, and the production line can continue to work. However, at the same time, it should be timely cooperated with the professional maintenance, non-professionals can not open the cover, so as not to calculate bad parts. Oil sealant must be applied for sealing before each cover.