Suspended permanent magnet iron remover felt ring should be replaced after wear- RCYD
the email of beltmagnets factory

HomeNews › Suspended permanent magnet iron remover felt ring should be replaced after wear

Suspended permanent magnet iron remover felt ring should be replaced after wear

The inner sprocket cover inner felt strip and the large sprocket lower felt ring of the suspended permanent magnet iron remover are designed to ensure the seal of the chassis and effective breathing, and can not be damaged during maintenance; the felt ring should be timely after being worn for a long time. Replace it. If the powder has a small particle size (≤ 1mm). The content of ferromagnetic material is high. It is customary for the powder to be entrained in the discharge of the taphole to be increased. If the amount of the effluent is large and the user wants to recycle the contained materials, a permanent magnet sorter for the accessory product can be purchased. Before starting the machine, the operator must open the observation port cover to check whether there is a heavy iron piece on the inner diaphragm of the suspended permanent magnet separator (especially the tap hole). If there is one, it must be cleared before it can be activated.

The dust on the suspension type permanent magnet iron reducer motor should be removed every shift; the oil-reducing hole of the geared motor and the chain on the machine side should be added with calcium-based grease every six months; the lubricating oil in the oil groove at the bottom of the chassis should be replaced every 12 months. When the temperature exceeds 100 °C, the oil change time should be shortened. Once the suspended permanent magnet iron remover has a mechanical failure and the production line is temporarily inconvenient to stop, the power of the machine can be turned off, and the operator can take out the iron from the observation port, and the production line can continue to work. However, at the same time, it should be promptly repaired with professionals. Non-professionals are not permitted to open the cover without authorization to avoid damage to the machine. Oil sealant seals must be applied before each cover.

 

Suspended permanent magnet