What are the points to master when installing the Overband Magnet separator- RCYD
the email of beltmagnets factory

HomeNews › What are the points to master when installing the Overband Magnet separator

What are the points to master when installing the Overband Magnet separator

The installation of Overband Magnet iron remover is not very complicated to install, and the installation itself can save a large part of the cost. Next, we will introduce the maintenance and installation of the Overband Magnet separator.

1. Before installation, the equipment must have a space device, operation and unloading space.

2. Check the insulation resistance of the iron remover before the installation. The resistance value should be above 1 megohm. If the moisture is lower than 1 megohm, turn on the power supply controller and turn on the excitation coil for 2-3 hours. Measure the insulation resistance. If it is less than the specified value, continue to energize until the specified value stops.

3. When the equipment is installed, first install the bracket according to the outer dimensions and suspension dimensions of the iron remover, then install the iron remover above the belt and firmly fix it on the bracket. The angle of the steel rope between the two rings canbe more than 90. °.

4. Adjust the basket screw on the four rings according to the rated suspension height of the iron remover, and adjust to the standard height to be put into service.

5. After the iron remover is made available for operation, it is necessary to timely dispose the ferromagnetic substance adsorbed on the iron remover. If it is not opportune, it will affect the effect of iron removal. When it finishes, it only needs to be powered off.

6. If you encounter metal materials that cannot be adsorbed by the iron remover, you can install a metal detector.

7, the machine should be firmly grounded.

 

Overband Magnet