What are the requirements for the maintenance of suspended permanent magnet separator bearings- RCYD
the email of beltmagnets factory

HomeNews › What are the requirements for the maintenance of suspended permanent magnet separator bearings

What are the requirements for the maintenance of suspended permanent magnet separator bearings

The correct operation is the basis for ensuring the effective operation of the suspended permanent magnet separator. When the permanent magnet separator is turned on, the water should be fed first, and the water should be stopped after stopping the mine. The order cannot be reversed. In the suspended permanent magnet separator, the bearing plays a very important role, so the maintenance of the bearing is also very important, so what are the requirements for the maintenance of the bearing, lets’s take a look at it.

Generally speaking, suspended permanent magnet iron remover should clean the bearing after three hundred hours of operations, and then add lubricating oil. Added lubricating oil is preferably one-third of the bearing seat empty space, and the maximum should not exceed two-thirds. First, it is not required to tighten the cap of the capped oil cup before working on the permanent magnet separator. However, when the bearing of the suspended permanent magnet separator is worn or damaged, it needs to be replaced immediately, and attention should be given to the lubrication of the bearing.

In addition, the screen of the suspended permanent magnet iron remover is made of thin steel plate or iron sheet punching. The long-term use may cause the screen to wear or be broken down by other objects. If the damaged area is not that large, it can be repaired. If a larger area is damaged, the new screen should be replaced in time.

 

suspended permanent magnet