What is the correct operation to adjust the position of the suspension magnetic separator- RCYD
the email of beltmagnets factory

HomeBlog › What is the correct operation to adjust the position of the suspension magnetic separator

What is the correct operation to adjust the position of the suspension magnetic separator

Many users who use iron removal equipment are not very clear about how to properly adjust the suspension deviation of the suspension magnetic separator. However, it is very necessary for the user to master the adjustment method. So here are some related operations for the suspension adjustment of the suspension magnetic separator.

Before adjusting the suspension, adjust the roller bracket first so that the belt is biased to one side, and then adjust the roller bracket in the direction shown in the figure. Adjust repeatedly until the belt reaches a better position. Before adjusting the drive or reversing the roller, find out the correct installation position.

1. Adjust the roller bracket to the proper position. Then, adjust any one of the driven roller bearing seats to the proper position. If the driven roller bearing housing has been adjusted to this amount, adjust the other driven roller bearing housing until the belt is disconnected.
2. Adjustment of the deviation of the two-way operation conveyor. It is more difficult to adjust the deviation of the belt deviation of the two-way operation conveyor than the deviation of the one-way belt conveyor. When performing specific adjustment operations, you need to adjust one direction before adjusting the other direction.
During the adjustment operation, the relationship between the movement direction of the belt and the deviation trend should be carefully observed and adjusted one by one. The focus should be on the adjustment of the driving roller and the redirecting roller, and then adjust the blanking point of the idler and the material. At the same time, it should be noted that when the joint is vulcanized, the belt should be subjected to uniform stress in the longitudinal direction of the belt, and when using the guide chain, the forces on both sides should be as equal as possible.

Belt Magnetic